Filament Drying Desiccant (2pck)

Filament Drying Desiccant (2pck)

369,-
Ink. mva
Varenr:31251

Hold filamentet tørt!

Vått filament kan skape mange problemer. Faktisk så kan veldig mange problemer skyldes fuktig filament, men man skylder ofte på hotenden istedenfor.
Slice Engineering desiccant pack kan hjelpe med å løse dette problemet.

Dette er en medium stor boks i rustfritt stål som inneholder et svært effektivt avfuktingsmiddel.
Den passer inn i senteret til de fleste filamentruller og kan også settes inni en lukket 3dprinter for å holde området tørt.

Avfuktingsmiddelet kan tørkes og gjenbrukes evig !

Denne pakken inneholder 2stk

Antall:
-+
12 På lager
Beskrivelse
  • Activated alumina desiccant is 10x more powerful than comparable silica gel, and is non-toxic!
  • Creates enough of a relative humidity (Rh) gradient to absorb both surface moisture and water particles captured inside the filament
  • Stainless steel canister is perfectly sized to fit in the center of your filament spool
  • Desiccant is infinitely rechargeable in the stainless steel container
  • Humidity indicator card included
  • RoHS and REACH compliant
  • Made in USA!

To use simply remove the outer shrink wrap and pop off the cap, then insert the canister into the center of your filament spool. Store the spool in an airtight container and watch the humidity drop! More information can be found here.

Want to see testing to verify that the Filament Drying Desiccant is as amazing as Slice Engineerinhg say it is? Check out our Desiccant Activation Testing White Paper!

Teknisk info

Produktinformasjon

Tørkevariant Passiv