Prusa Mini Extruder Oppgradering til IFS

kr 429

TOMT PÅ LAGER

- Send meg varsel når varen er kommet på lager -

Oppgrader din Bondtech Prusa Mini extruder til å nå støtte Internal Filament Sensor

Dette er et sett med SLS nylon deler som lar deg oppgradere Bondtech Extruder til Prusa Mini, til å støtte IFS (Internal Filament Sensor)

NB, IFS er ikke inkludert
Kan fint brukes uten sensor

Prusa Mini Extruder Oppgradering til IFS

kr 429

TOMT PÅ LAGER

- Send meg varsel når varen er kommet på lager -

SKU EXT-KIT-83 Kategori

Beskrivelse

Upgrade Your Prusa Mini or Mini+

This set may be used on the Prusa Mini or Mini +.

Filament Sensor Compatible

The Bondtech Internal Filament Sensor Extruder for Prusa Mini may embed the new Prusa filament sensor for Mini or Mini+ on its front housing.
The extruder may be used with or without the filament sensor.
Use this set of parts to make your original Prusa Mini Extruder compatible with IFS.

Front Housing Plug

The front housing of the IFS Extruder for Prusa Mini includes a plug that is just a placeholder for the filament sensor steel sphere, and it allows the extruder to be used without a filament sensor.
If you want to use the IFS Extruder for Prusa Mini with the Prusa FIlament Sensor, remove the plug and follow the guide to install all the accessories required.

 

Included in this Kit

  • 1x 10076-3 Front Housing (PA12)
  • 1x 10076-4 IFS Magnet Holder (PA12)
  • 1x 10076-5 IFS Lever (PA12)
  • 1x 15112 IFS Extruder Plug (HT-PLA)

Not included in this Kit

  • Prusa Filament Sensor
  • Filament Sensor Magnets
  • Filament Sensor Steel Sphere
 

Community Sourced Design

The original Bondtech extruder for Prusa Mini design was proposed to us by Olof Ogland. This new IFS version was developed by Vecko Kojchevski on top of Olof’s work. It’s based on the thoroughly tested BMG (Bondtech Mini Geared) and adjusted to the Prusa Mini original design.

Product Info

EAN Code: 7350011413959
Net weight : 102.3g

Upgrading Prusa Mini From Bondtech Extruder To IFS Extruder
This guide may also be partially used to install the IFS Extruder for Prusa Mini.

If you are using firmware 4.3.3 there is a new way to update the e-steps value using the new Hardware Settings to customize the extruder. To adjust these settings for your custom extruder, go to
LCD Menu -> Settings -> HW settings -> then long-press the knob.
Similarly to the MK3S+, a new “Experimental” submenu will appear on the screen to that purpose.
Keep using the 415 value.

Merke

Bondtech

Tilleggsinformasjon

Vekt 0.062 kg
Dimensjoner 15 × 10 × 4 cm

Omtaler

Det er ingen omtaler ennå.

Bli den første til å omtale “Prusa Mini Extruder Oppgradering til IFS”

Din e-postadresse vil ikke bli publisert. Obligatoriske felt er merket med *

Tilsvarende Produkter