add:north Textura Flare Rocky Grey
add:north Textura Flare Rocky Grey add:north Textura Flare Rocky Grey add:north Textura Flare Rocky Grey add:north Textura Flare Rocky Grey add:north Textura Flare Rocky Grey

add:north Textura Flare Rocky Grey

Omtaler 0
SKU: texturaflaregrey Kategori:
Brand: add:north
kr499
TOMT I EN ELLER FLERE STØRRELSER

- Send meg varsel når varen er kommet på lager -

Textura Flare™

Ekstremt matt biobasert materiale. Optimalisert for estetisk utseende og perfekt for feks arkitekter / printing av bygninger o.l
Den er svært enkel å printe, enkel å post-prosessere og lett å male

Den matte overflaten gjør også at lagene er knapt synlige, noe som gir en svært pen overflate

Textura Flare har den fantastiske egenskapen at man kan kontrollere fargedybde og matthetsgrad ved å variere på tempereatur og printhastighet.

Filamenttykkelse: 1.75mm

Beskrivelse
  • PRINT GUIDE
    Temperatures and cooling

    Since this material is based on PLA, only minor changes are required from the standard settings for PLA. The temperature and the fan can be varied depending on if strong layer adhesion or ease-to-post-process i preferred. For good layer adhesion, print at around 205°C and use not more than 20-30% fan. If ease-to-post-process is preferred, print at 190°C and 80-100% fan.

    Build plate adhesion

    The build plate temp should be as with normal PLA, none or up to 65°C depending on your surface. PEI or BuildTak is recommended

    Quality

    Quality is a complex area where hardware and slicer have big impact. Every new filament needs in general some tuning to achieve its full potential, usually through printing some calibration models and adjusting iteratively. We have gathered our favourites here. To troubleshoot specific issues, we would like to refer you to our material guide – here are some general quality tips though:
    • Print speed, flow and layer height: As usual, lower layer heights and lower printing speeds yields higher detail sharpness, but takes longer time. We recommend to not go below 0.15mm. Recommended printing speed is 50mm/s, with a flow/extrusion multiplier of 0.9-0.95 to avoid over-pressure in the nozzle that could lead to clogs.
    • Feeder tension: It is recommended to decrease the feeder tension slightly compared to default setting, to avoid grinding the filament as well as over-pressurizing the nozzle.
    • Nozzles: It works with standard nozzle size of 0.4mm, but it is recommended to use 0.5mm or bigger to avoid clogging issues. If you are printing big objects (5h+) with a small nozzle (0.4mm), it is important to print at the lower end of the temp spectrum (185-190°C), keep retractions at a minimum and turn off the fan. The material is not abrasive on metal nozzles, and can be printed on standard nozzles.
    Misc: Remember to clean out the nozzle after the print to get rid of any fiber residues, and to keep the filament dry. Also, make sure the surrounding temp is not too high, 20°C is optimal. At 25°C+, some problems can occur.
Spesifikasjoner
Fraktvekt
1 kg
Farge

,

Størrelse

1.75mm

Netto filamentvekt

Omtaler (0)
Vær den første til å skrive omtale om dette produktet. Del din karakter og omtale slik at andre kunder kan bestemme seg for om dette er det rette produktet for dem.
Skriv en omtale
Din omtale
Din karakter
Name
Epost